Makita 1923H Betriebsanleitung Seite 11

NOTE:
When planing, move the tool with the edge fence
flush with the side of the workpiece. Otherwise
uneven planing may result.
Max. shiplapping depth is 23 mm.
Chamfering (Fig. 21, 22 & 23)
To make a cut as shown in Fig. 21, align the "V"
groove in the front base with the edge of the work-
piece and plane it as shown in the Fig. 23.
Nozzle assembly (optional accessory)
(Fig. 24)
Use of the special nozzle assembly will minimize chip
scatter, making for a cleaner work area.
Install the nozzle assembly (optional accessory) on
the tool using the screw as shown in Fig. 24.
Sharpening the planer blades
(Fig. 25, 26 & 27)
For standard blades only
Always keep your blades sharp for the best perfor-
mance possible. Use the sharpening holder to
remove nicks and produce a fine edge.
First, loosen the two wing nuts on the holder and
insert the blades (A) and (B), so that they contact the
sides (C) and (D). Then tighten the wing nuts.
Immerse the dressing stone in water for 2 or 3 min-
utes before sharpening. Hold the holder so that the
blades both contact the dressing stone for simulta-
neous sharpening at the same angle.
Connecting a vacuum cleaner
For European countries and areas
28 & 29)
(Fig.
When you wish to perform clean planing operation,
connect a Makita vacuum cleaner to your tool. Install
the nozzle (standard equipment) on the tool using the
screw provided. Then connect a hose of the vaccum
cleaner to the nozzle as shown in Fig. 29.
For other countries and areas
A nozzle and joint (optional accessories) are neces-
sary to connect a Makita vacuum cleaner to your tool.
Consult a Makita catalogue or representative on the
nozzle and joint.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes
(Fig. 30, 31 & 32)
Replace carbon brushes when they are worn down to
the limit mark. First, remove the chip cover and then
replace the carbon brushes. Both identical carbon
brushes should be replaced at the same time.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.
11