JUNO JM60170116 Benutzerhandbuch Seite 33

Connecting the appliance to the power
supply
(A)
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or it
should be possible to isolate the oven from
the supply by incorporating a switch in the
fixed wiring in accordance with the wiring
rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the cupboard,
see (A).
• Connect the appliance to a single phase
230 V/50 Hz alternating current via a
correctly installed earth socket. The socket
must be fused with a 10 A fuse.
• The power supply cord may only be
replaced by an electrician.
• If the supply cord is damaged it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
• Before installing, tie a piece of string to the
power supply cord to facilitate connection
to point (A) when the appliance is being
installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush the
power supply cord.
• Do not immerse the power supply cord or
plug in water or any other liquid.
• Do not allow the power supply cord to run
over any hot or sharp surfaces, such as the
hot air vent area at the top rear of the oven.
33