What To Do If - Zanussi ZUA12420 SA Benutzerinformation

Cleaning the air channels
1. Remove the
plinth (1), then
the ventilation
grille (2);
2. Clean the ventila-
tion grille and the
filter. ( Refer to "
Cleaning the
ventilation filter
". )
3. Carefully pull the
air deflector out
(3), checking that
there is no water
left from the de-
frosting.
4. Clean the lower
part of the appli-
ance with a vac-
uum cleaner.
Cleaning the ventilation filter
The appliance is equipped with an air inlet filter
(1) and an air outlet duct (2) on the ventilation
grid.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
8
2 1
3
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The filter can be re-
moved for washing.
1. Pinch flaps (a)
and (b) with fin-
gers.
2. Pull the filter
down.
3. Pull the filter out.
To replace the filter
reverse the process.
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
1. disconnect the appliance from electricity
supply
2. remove all food
3. defrost and clean the appliance and all ac-
cessories
4. leave the door/doors open to prevent un-
pleasant smells.
Important! If the cabinet will be kept on, ask
somebody to check it once in a while to prevent
the food inside from spoiling in case of a power
failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
2
a b
1
Solution
www.zanussi.com