Replacing The Lamp; Troubleshooting - AEG S72300DSX1 Benutzerinformation

6.4 When the appliance is not
used for long periods
1. Deactivate the appliance and discon-
nect the mains plug from the mains
socket.
2. Remove all the food.

6.5 Replacing the lamp

7. TROUBLESHOOTING

WARNING!
Disconnect the mains plug from
the mains socket before you do
the check.
For problems that are not in the
table, contact the Service.
Problem
The appliance makes
noise during operation.
The appliance does not
operate.
3. Defrost the appliance.
4. Fully clean and dry the appliance and
all the accessories.
5. Keep the doors open to prevent un-
pleasant smells.
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover
4. Replace the old lamp with a new
one. Use only lamps for household
appliances. The lamp cover shows
the maximum power of the lamp.
5. Install again the lamp cover.
6. Connect the mains plug to the mains
socket.
Possible solution
Some sounds are normal when the appliance is
operating. Refer to the leaflet supplied with the
appliance.
Make sure that the appliance is activated.
Make sure that the mains plug is connected to the
mains socket.
Do a check and see if there is voltage. Connect a
different appliance to the same mains socket. To
repair a mains socket, contact a qualified electri-
cian.
The type of light bulb or halogen
lamp used for this appliance, is
only for household appliances.
Do not use it for house lightning.
ENGLISH
21