Care And Cleaning; Defrosting Of The Freezer - AEG S72300DSX1 Benutzerinformation

20 www.aeg.com

6. CARE AND CLEANING

CAUTION!
Before maintenance, disconnect
the mains plug from the mains
socket.
6.1 Cleaning
• Clean the appliance and the accesso-
ries regularly.
• Clean all the parts of the appliance
and all the accessories only with warm
water and neutral detergent. Make
sure that the appliance and the acces-
sories are fully dry.
• Clean the gasket of the door regularly.
To replace a damaged gasket, contact
the Service.
• Clean the grill of the condenser and
the compressor, that are behind the
6.2 Automatic defrosting of the fridge

6.3 Defrosting of the freezer

There can be frost on the freezer
shelves and around the top com-
partment.
Defrost the freezer when the lay-
er of frost has a thickness of 3 or
5 mm.
CAUTION!
Do not use sharp metal tools to
remove the frost.
Do not use mechanical devices
to defrost the freezer.
1. Deactivate the appliance.
appliance, with a brush. This helps to
decreases the energy consumption
and keeps the appliance in good con-
ditions.
• Be careful not to pull, move or
to cause damage to the pipes
or the cables.
• Be careful not to cause dam-
age to the cooling unit.
• Do not clean the appliance
with abrasive products, abra-
sive cleaning pads, solvents,
detergents with perfume or
wax polish.
After maintenance, connect the mains
plug to the mains socket.
The removal of frost occurs automatically
when the motor compressor stops dur-
ing operation.
The water drains out through the drain
hole and collects in the water container
where it evaporates.
The water container is behind the appli-
ance, above the motor compressor.
The drain hole is in the fridge on the rear
part.
To prevent water to collect in other parts
of the fridge, make sure that the drain
hole is always clean. Use the cleaning
tool that is in the drain hole.
2. Remove all the food from the freezer.
Wrap the food in newspaper and
keep it at a cold temperature.
3. Keep the appliance door open until
defrosting is completed.
4. Clean and fully dry the freezer.
5. Connect the mains plug to the mains
socket.
6. Activate the appliance.
7. Set the temperature knob at the
highest position and let the appli-
ance operate for 2 or 3 hours with
this setting.
8. Put back the food in the freezer.