Cleaning Or Replacing The Lamps In The Shoulder Tanner - ergoline AFFINITY 990 HYBRID PERFORMANCE SLP AC PLUS Gebrauchsanweisung

07/2017 1018447-00
– Remove the lamps.
– Remove the two upper low pressure lamps in the canopy so that you can
then access the facial tanner's low pressure lamp starter.
Replacing lamps: see page 52.
Replacing starters: see page 53.
UV high pressure lamps and filter panels: see page 54.
The assembly is the same process in reverse order.
When assembling the device please note:
– Support the canopy panel with one hand so that it does not fall down.
– Re-lock the locks: first the lock in the middle, then the outer locks.
4.12 Cleaning or replacing the lamps in the
shoulder tanner
DANGER!
Danger of burns from hot lamps and surfaces!
Finger and hands may get burned when replacing lamps
and filter panels or cleaning reflectors.
– Before carrying out maintenance work, wait until the
device has cooled down sufficiently.
– Opening the bed base: see page 49.
Cleaning and maintenance
Operating instructions – 57/78