Replacing The Lamp; Closing The Door - Electrolux ERB36300W Benutzerinformation

Problem
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the
refrigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre.

Replacing the lamp

1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.
Possible cause
The door is not closed correctly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
1

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
electrolux 23
Solution
2