What To Do If - Electrolux ERB36300W Benutzerinformation

22 electrolux
• when all the ice has melted, clean and
wipe the cabinet dry, then put the drain-
age channel back in place.
• switch on the cabinet and replace the
frozen foodstuff.

WHAT TO DO IF...

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Problem
The appliance is noisy.
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
There is too much frost
and ice.
Possible cause
The appliance is not supported
properly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Products are not wrapped prop-
erly.
It is recommended to operate the ap-
pliance at the highest position of the
thermostatic control for some hours so
that it can reach the sufficient storing
temperature as soon as possible.
Important! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it. Do not use a mechanical
device or any artificial means to speed up
the thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Check if the appliance stands sta-
ble (all the four feet should be on
the floor).
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Wrap the products better.
Solution