Sound Controlled Mode; Auto Mode; Static Color Mode; Other Mode - EuroLite LED SLS-3 HCL 3x10W floor Bedienungsanleitung

Sound controlled mode

Press the MODE button to select the sound controlled mode.
In sound controlled mode there are 2 sub-menus to choose from. Please press the SET UP button to reach
the selection.
At ~ you can select the desired programs via the UP or DOWN buttons.
At ~ you can select the desired sensitivity via the UP or DOWN buttons.

Auto mode

Press the MODE button to select the auto mode.
In auto mode there are 3 sub-menus to choose from. Please press the SET UP button to reach the selection.
At ~ you can select the desired fading color program via the UP or DOWN buttons.
At ~ you can select the desired switching color program via the UP or DOWN buttons.
At you can select the auto fade and switch program which runs in a continuous loop via the UP or
DOWN buttons.
At ~ you can select the desired speed of the programs in auto mode via the UP or DOWN
buttons.

Static color mode

Press the MODE button to select the static color mode.
In this mode there are 2 sub-menus to choose from. Please press the SET UP button to reach the selection.
At ~ you can select the desired color via the UP or DOWN buttons.
At ~ you can select the desired flash speed of the selected color via the UP or DOWN
buttons.

Other mode

In this mode there are 3 sub-menus to choose from. Please press the SET UP button to reach the selection,
as appropriate.
At and
if it should turn off after 60 seconds of inactivity.
At and
or if it should display upside-down.
At you can reset to ex works setting. Please push the UP and DOWN buttons at the same time. The
display shows

DMX-mode

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button to select the DMX mode until the display shows
You can select the desired addresses via the UP or DOWN buttons.
via the UP or DOWN buttons, you can decide if the display should always be on, or
via the UP or DOWN buttons, you can decide if the display should display normally,
and the color switching programs begins to run.
24/27
~ .
00080993.DOC, Version 1.0