Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX-protocol
Channel 1
Dimmer
0 -255
0-100 % LED brightness
Channel 2
Strobe
0 - 255
0-100 % with increasing speed
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder with a fitting screwdriver from the housing (anti-clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
Inserting/Replacing the battery
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
Danger of explosion when battery is replaced improperly.
Caution!
22/23
00074359, Version 1.0
Werbung
Inhaltsverzeichnis
