Closing The Product - Mennekes AMTRON Compact 2.0 11 Betriebs Und Installationsanleitung

The following advanced settings can be made:
n Perform firmware update
n Change the default setting (16 A) for the unbal-
anced load limitation (possible values:
10 A ... 30 A)
n Deactivate acoustic feedback
n Deactivate Sleep mode (for reduced standby
consumption of approx. 1 W)
n Activate undervoltage / overvoltage detection
for the connected phases and set the respect-
ive limit values
n Import and export settings
n Convert the enable input to a pulse signal
In addition, the current operating values are dis-
played and the DIP switch settings are explained in
the configuration tool. Should a fault occur, the con-
figuration tool offers assistance with troubleshoot-
ing (fault message, log file).
To use the configuration tool, the MEN-
NEKES configuration lead is required. You
can find the MENNEKES configuration lead
(order number 18625) on our website under
"Products" > "Accessories". You can also
download the configuration tool and in-
struction manual there.
The instruction manual for the configuration tool
describes how to install and use the tool.
1 Comply with the configuration tool manual.
Structure
1
3 4 5
7
Fig. 13: Configuration tool setup (example)
1 Language selection button
2 Connection status
3 Menu
4 Tool tip with more information
5 Parameter
6 Setting / status
7 Buttons to save and discard the changed set-
tings and to reset to the factory settings
6.6

Closing the product

The tasks described in this section may only
be carried out by a qualified electrician.
ATTENTION
Material damage due to crushed components or
cables
Damage and malfunctions can occur due to
crushed components or cables.
u When closing the product ensure that compon-
ents or cables are not crushed.
u Fix components or cables in place if necessary.
2
EN
6
21