AUDIOLINE DECT 7501 micro Bedienungsanleitung Seite 32

All manuals and user guides at all-guides.com
- General Information -
Private branch exchanges -The telephone can also be connected to a private
branch exchange. The dealer where you purchased the private branch exchange
will tell you if your telephone will work properly on your PBX. Due to the great
variety of private branch exchanges, we cannot guarantee that the phone will work
properly on all PBXs.
Location of the base station - The base station must be located within reach of a
230Volt supply socket. To avoid interference problems, do not place the base
station in the immediate proximity of other electronic equipment such as a
microwave oven or hi-fi system. The location of the base station can significantly
influence the proper function of the telephone.
Place the base station on a level, non-slip surface. The feet of the base station will
not normally mark the surface on which it stands. However, the wide range of
surface finishes in use renders it impossible to exclude marking of any surface.
Do not use the handset in areas where there is a danger of explosion.
Avoid excessive exposure to smoke, dust, vibration, chemicals, humidity, high
temperature or direct sunlight.
Note for medical products - The telephone works with very low transmitted
power. Present knowledge and research indicate that, at this low power level,
there is no possible danger to health. It has, however, been shown that portable
telephones, when switched on, can affect medical equipment. Maintain a distance
of at least one metre from medical equipment.
Disposal - If the accupacks or the complete system have reached the end of their
useful life, please dispose of them in an environmentally friendly manner and as
required by law.
Temperature and ambient conditions - The telephone is designed for indoor use
and an operating temperature range of 10 °C to 30 °C. The base station must not
be installed in humid areas such as bath or wash rooms. Avoid proximity to
sources of heat such as radiators and do not expose the unit to direct sunlight.
Cleaning and care - The outer surfaces of the unit can be cleaned with a soft, dry,
lint-free cloth. Never use cleaning agents or aggressive solvents. Apart from
occasionally cleaning the outer surfaces, no further care is required. The rubber
feet of the base station are not resistant to all cleaning agents. The manufacturer
cannot, therefore, be held responsible for damage to furniture etc.
CE marking - The telephone is compliant with the essential requirements of the
R&TTE Directive. This is certified by the CE marking.
32