EMPHASER EA-MT1 Einbau & Bedienungsanleitung Seite 3

CONNECTIONS + CONTROLS EA-MT1
1 Turn-On Mode
Slide switch to select the Auto-Turn-On function: Signal by music signal,
DC to switch on by DC offset signal of the head units integrated amplifier,
REM by remote wire.
2 INPUT GAIN CONTROL
Input gain potentiometer to match the output voltage of the head-unit to the amplifier's
input.
3 SUBSONIC FREQUENCY CONTROL
Control potentiometer to adjust the crossover subsonic filtering frequency point of the
amplifier.
4 BASS BOOST
To increase bass performance from 0 – 15 dB @ 40 Hz.
5 LOWPASS FREQUENCY CONTROL
Control potentiometer to adjust the crossover lowpass filtering frequency point of the
amplifier.
6 PHASE SHIFT CONTROL
Control potentiometer for variable phase adjustment of the signal of the amplifier.
7 PROTECT LED
Protect state of amplifier is signaled by the red LED.
8 POWER LED
LED to show proper operating status of the amplifier by green illumination.
9 SPEAKER OUTPUT TERMINAL
Output terminal to connect the speakers to the amplifier.
10 REMOTE CONTROL
Port for the provided remote control (EA-MT1 only).
11 RCA INPUTS CH1/CH2
Low-level stereo RCA signal input CH1/CH2 for connection to the head-unit.
12 SPEAKER INPUT TERMINAL
Input terminal to connect the speaker cables of the head unit to the amplifier.
13 "REM" INPUT TERMINAL
Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the
head unit.
14 "+12V" POWER INPUT TERMINAL
Terminal to connect the amplifier to the positive +12V pole of the car battery.
15 "GND" POWER INPUT TERMINAL
Terminal to connect the amplifier to the chassis ground or negative pole of the car battery.
4
Control panel
1
bq bp bo bn bm
2 3 4 5 6 7
bl 9 8
5