HEYLO DS 65 T Betriebsanleitung Seite 31

1
Fig. 29: Wheel position 1 - for empty/half full tank
1 Device base screws
Fig. 30: Wheel position 2 - for full tank
a) Loosen the screws connecting the base and the
tank at both sides.
b) Move the tank to the desired position.
c) Tighten the screws connecting the base and the
tank at both sides.
Refuelling
Fig. 31: Refuelling
1 Fuel tank cap
a) Open the fuel tank cap and fill the tank with a
suitable fuel (see also Fuel
NOTICE! Use only fuels that are suitable for
the device.
b) Close the fuel tank cap.
EN
1
[ 25]).
Installing device on site
To install the device on site, observe the Operating
conditions [ 26] and the following rules:
– Install the device in a position where the air flow
through the inlet and outlet openings is not ob-
structed.
– Place the device in a position where air circula-
tion is unobstructed; maintain a minimum clear-
ance of 50 cm to the nearest wall or object at
both the air inlet and outlet side.
– Do not place the device on a wet surface.
– The device must be in a stable position so that it
cannot topple over or roll away during operation.
Connecting device to power supply
a) Connect the device to a power socket that is
earthed or protected by an integrated RC circuit
breaker (see Technical data and factory settings
[ 39]).
 The device is now installed and ready for opera-
tion.
Connecting external room thermostat
NOTICE
Use original accessories
To ensure reliable device operation, only connect
original accessories to the device.
4
3
2
Fig. 32: Connecting thermostat
1 Thermostat
3 Protective cap
✓ The device is in standby mode – the device is
switched off and the power plug is connected.
a) Remove the protective cap from the device
socket.
b) Plug the thermostat plug into the socket and
lock the plug.
c) Place the thermostat in a suitable position.
Oil heater DS 65 T
1
2 Thermostat plug
4 Socket on device
31 / 40