Safety - HEYLO PV 3000 Betriebsanleitung

Address: HEYLO GmbH
Im Finigen 9
28832 Achim
Tel. no.: +49 (0) 4202 / 97 55 0
Fax: +49 (0) 4202 / 97 55 97
Email: info@heylo.de
Internet: http://www.heylo.de
Tab. 6:
Registered office
Address: HEYLO (Switzerland) AG
Südstraße 16
CH-3250 Lyss
Tel. no.: +41 (0) 32 / 387 16 80
Fax: +41 (0) 32 / 387 16 85
Email: info@heylo.ch
Internet: http://www.heylo.ch
Tab. 7:
Registered office in Switzerland
13

Safety

The device is built using state-of-the-art technology
and in accordance with the recognised safety rules.
Nonetheless, danger to the life and limb of the oper-
ator or third parties may arise if it is not used proper-
ly. Similarly, the device or other property and mate-
rial may become damaged.
The device must only be used:
– for the purpose for which it was intended
– and when it is in perfect technical condition.
The device must not be restarted until any fault that
may impair safety has been rectified.
Any persons installing, operating, maintaining or
cleaning the device must be aware of the hazards
that may arise from electrically operated equipment
in environments with a high humidity, and they must
have read and understood this operating manual.
EN
Avoiding dangerous situations
The following instructions apply to anyone working
on or with the device:
– The operating manual must be kept at hand, in
complete and legible form, at the place where
the device is used.
– The device may only be used for its intended
purpose.
– The device must be fully functional and in fault-
less condition. The condition of the device must
be checked regularly before use.
– Accident prevention regulations and any local
rules must always be adhered to.
Information on electrical equipment
During all work on electrical equipment, the following
principles apply:
– The device is operated electrically. There is a
risk of fatal injury from faulty installation of the
electrical system or from a breakdown of the in-
sulation during operation.
– Only electricians are allowed to access and work
on electrical equipment. Always keep switch-
boxes closed.
– On completion of any work ensure that all safety
equipment is functioning properly.
– No unauthorised modifications may be made to
the device.
– The device is not approved for operation in are-
as with an explosive atmosphere.
Information on transport and installation
During transport and installation, the following prin-
ciples apply:
– Check the device on receipt and before every
use for visible turbine blade, covering or housing
damage. Any and all such damage must be rec-
tified before the device may be operated.
Fan PV 3000
23 / 36