Lubricating Oil; Sun Visor - AGV Tourmodular Gebrauchsanleitung

6 LUBRICATING OIL

Applying silicone oil to the visor mechanism prevents the onset of corrosion and both-
ersome creaking.
Prerequisite: the helmet is placed on one of its two sides.
• Remove the visor (see 5.3).
• Apply a moderate amount of oil to the visor mechanism of the helmet.
• Wipe off any excess oil with a cloth.
• Replicate the operations on the visor mechanism on the other side of the helmet.
›
Install the visor (see 5.4).
In case of contact with skin, wash thoroughly with plenty of soap and water. In case of contact
with eyes, wash with plenty of water and seek medical advice. If swallowed, seek medical
advice. In case of inhalation, breathe in fresh, open air. Avoid exposure to sunlight. Store in a
dry place at a temperature below 50°C. Keep out of the reach of children and animals.
Do not allow the product to penetrate into the soil/subsoil. Do not allow product to
reach surface water and/or sewage systems. Keep contaminated washing water con-
tained and dispose of it appropriately. In case of penetration into watercourses, soil or
sewage systems, inform the relevant authorities. Suitable material for collection: ab-
sorbent material, organic material, sand. Do not litter the container in the environment.
7 AGV INSYDE COVERS
Do not remove the covers of AGV Insyde if you have not purchased AGV Insyde yet and
if you are not just about to assemble it. To remove the AGV Insyde covers refer to the
AGV Insyde assembly booklet, provided with the accessory. Removing the covers im-
properly and without having the instructions can damage the product.
12

8 SUN VISOR

Made of scratch-resistant polycarbonate, the sun
visor improves comfort and offers protection from
UV radiation. Transmittance varies between 20%
and 35% depending on approvals. The sun visor
can be used with the chin guard raised. In this
configuration it protects the eyes from dust and
debris. The position can be adjusted based on the
shape of the nose.
The sun visor must only be used during the
day in optimal visibility conditions. It must
never be used at night, at dawn, at sunset, or
when weather conditions do not allow per-
fect visibility.
8.1 OPERATION
AND ADJUSTMENT
›
To lower the sun visor, push the operating slider
towards the back of the helmet.
›
Once lowered, the sun visor can be adjusted by
regulating the last 5 mm of travel.
8.2 REMOVAL
AND INSTALLATION
Prerequisite: in a seated position, rest the helmet on your
knees. Raise the chin guard and lower the sun visor.
• Grasp the sun visor and push it towards the
inside of the shell until the plastic tab
taches from its housing
›
Repeat the operations above on the other side
1
mechanism.
›
To install the sun visor, repeat the previous op-
2
erations in reverse order, taking care to ensure
correct movement.
.If there are difficulties to remove the
sun visor, please, use the tool provided
with the helmet. Insert the tool betwe-
en the sun visor and the slot
EN
IT
FR
DE
ES
PT
РУ
中文 中文
1
de-
2
.
13