Display Settings - Kenwood KDC-BT460U Bedienungsanleitung

Audio Settings
– [SUBWOOFER] is selectable only when [SWITCH PREOUT] is set to [SUB-W]
(page 5) and [SUBWOOFER SET] is set to [ON] (page 16).
When 3-way crossover is selected:
[TWEETER LEFT]/[TWEETER RIGHT]/[MID LEFT]/[MID RIGHT]/[WOOFER]
– You can only select [WOOFER] if a setting other than [NONE] is selected for
[WOOFER] of [SPEAKER SIZE]. (Page 18)
• [R-SP LOCATION] of [CAR SETTINGS] is selectable only if:
– 2-way crossover is selected. (Page 6)
– A setting other than [NONE] is selected for [REAR] of [SPEAKER SIZE].
(Page 18)
Determining the delay time automatically
20
ENGLISH
If you specify the distance from the currently set
listening position to every speaker, the delay time will
be automatically calculated.
1 Set [POSITION] and determine the listening
position as the reference point (the reference point
for [FRONT ALL] will be the center between the
right and left in the front seats).
2 Measure the distances from the reference point to
the speakers.
3 Calculate the distance between the furthest speaker
(subwoofer on the illustration) and other speakers.
4 Sets the [DISTANCE] calculated in step 3 for
individual speakers.
5 Adjusts [GAIN] for individual speakers.
Example: When [FRONT ALL] is selected as the
listening position.

Display Settings

Zone identification for brightness setting
Set the dimmer
Press and hold DISP to turn on or off the dimmer.
• Once you press and hold this button, [DIMMER] setting (page 21) will be
overwritten.
Change the display settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (page 21), then press the
knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press .