Kenwood KDC-BT460U Bedienungsanleitung Seite 35

Troubleshooting
Symptom
Playback order is not as
intended.
Elapsed playing time is not
correct.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the device (USB).
"UNSUPPORTED DEVICE" • Check whether the connected USB device is compatible
appears.
• Reattach the USB device.
"UNRESPONSIVE DEVICE"
appears.
"USB HUB IS NOT
SUPPORTED" appears.
• The source does not change
to "USB" when you connect
a USB device while listening
to another source.
• "USB ERROR" appears.
"NO DISC"
"TOC ERROR"
"NA FILE"
"COPY PRO"
Remedy
Optical disc, the files are played in the order which they
were recorded.
USB device, the folders are played in the order of creation
(date and time). The files within each folder are played in
the order of the file name (alphabet).
This depends on the recording process earlier.
with this unit and ensure the file systems are in
supported formats. (Page 25)
Make sure the USB device is not malfunction and reattach
the USB device.
This unit cannot support a USB device connected via a
USB hub.
The USB port is drawing more power than the design
limit. Turn the power off and unplug the USB device.
Then, turn on the power and reattach the USB device.
If this does not solve the problem, turn the power off and
on (or reset the unit) before replacing with another USB
device.
Insert a playable disc into the loading slot.
Make sure the disc is clean and inserted properly.
Make sure the media contain supported audio files.
(Page 25)
A copy-protected file is played.
Symptom Remedy
"NO DEVICE" Connect a device (USB), and change the source to USB
again.
"NO MUSIC" Connect a device (USB) that contains playable audio files.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. (Page 3)
Bluetooth pairing cannot • Make sure you have entered the same PIN code to both
be made. the unit and Bluetooth device.
• Delete pairing information from both the unit and
the Bluetooth device, then perform pairing again.
(Page 11)
Echo or noise is heard during a • Adjust the microphone unit's position. (Page 11)
phone conversation. • Check the [ECHO CANCEL] setting. (Page 12)
Phone sound quality is poor. • Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
Voice calling method is not • Use voice calling method in a more quiet environment.
successful. • Reduce the distance from the microphone when you
speak the name.
• Make sure the same voice as the registered voice tag is
used.
Sound is being interrupted or • Reduce the distance between the unit and the Bluetooth
audio player.
skipped during playback of a
Bluetooth audio player. • Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the
unit.
27
ENGLISH