Replacing The Lamp; Closing The Door - Electrolux SB330NIMS Benutzerinformation

Problem
The Wi-Fi does not con‐
nect with the appliance,
the Wi-Fi indicator blinks.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

9.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
There is no cold air circula‐
tion in the appliance.
The Wi-Fi router does not
work.
The router needs a restart. Restart the router by un‐
Your connected appliance
needs a Wi-Fi reset.
Your appliance is out of
range from the router.

9.4 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Make sure that there is
cold air circulation in the
appliance. Refer to the
"Hints and tips" chapter.
Check whether the router
is ON and if other connec‐
ted devices are working. If
the router was OFF, turn it
ON, wait for a few minutes
and check again.
plugging and plugging it.
Wait a few minutes and
check again.
Reset the Wi-Fi connection
by pressing and holding for
10 seconds Control Pan‐
el's Freezer compartment
control and Mode buttons.
Wait a few minutes and
connect again. Refer to the
"Wi-Fi connectivity setup"
chapter.
Make sure your appliance
is within 10 metres range
from your router and with
not too many walls in be‐
tween.
Connect your appliance to
the 2,4 GHz band on your
WiFi router when onboard‐
ing instead of the 5 GHz
band. This will give a stron‐
ger and longer range sig‐
nal.
103