Pelgrim PF8231WIT Anleitung Seite 53

YOUR COOKER
Safety metal parts
• A small object like a pan that is too small (diameter of bottom
smaller than 12 cm), a fork or a knife will not be recognised by
the appliance. The display continues to flash and the hob will not
switch on.
Overheatingprotection
The appliance may become overheated if:
• the pan does not conduct the heat adequately;
• fat or oil is heated at a high setting;
• there is insufficient circulation of air (see also ventilation protection
in the installation part of this manual).
In the event of overheating the result will be that the cooking zone
in question or all the cooking zones will display one of the following
reactions:
• the appliance will reduce the power a little;
• in case this will not help the appliance will switch off and E2 will
appear in the displays.
If the appliance has cooled down sufficiently, E2 will disappear and you
can switch the appliance on again.
Prevent the overheating protection becoming activated by:
• using pans that are good conductors of heat;
• heating up fat or oil at a lower setting;
• making sure there is sufficient ventilation.
If, despite the above-mentioned measures having been taken,
the overheating protection becomes activated again, contact the
service department or a professionally qualified specialist.
EN 13