Daikin EKHHE200CV37 Benutzer- Und Installationsanleitung Seite 18

6.5.1 Condensate drain connection
The condensate forming during heat pump operation flows
through a special drain pipe (1/2"G) that passes inside the insu-
lating casing and comes out at the side of the equipment.
It must be connected, via a trap, to a duct so that the conden-
sate can flow regularly (fig. 18).
fig. 18- Examples of condensate drain connection via a trap
Page 18
6.6 Integration with solar thermal system (only for models
EKHHE200PCV37, EKHHE260PCV37)
The following figure (fig. 19) shows how to connect the equip-
ment to a solar thermal system controlled by a dedicated elec-
tronic controller (not supplied) that has a "voltage-free contact"
type output to be connected to the DIG.1 input of the equipment
(see "6.7.1 Remote connections").
To use the equipment in this configuration it is necessary to set
the parameter P16 = 1 (see par. 8.1).
20
19
26
5 18
OUT
25
16
IN
1
fig. 19
The following figures (fig. 20 and fig. 21) show how to connect
the equipment to a solar thermal system controlled directly by
the latter, without the aid of a dedicated electronic controller.
In the configuration of fig. 20, in case of solar collector overtem-
perature a drain valve (not supplied) is activated to discharge in
a DHW storage tank (puffer) hot water contained in the equip-
ment.
In the configuration of fig. 21, however, in this condition the solar
collector shutter is closed.
In both cases this occurs in order to allow the collector to cool
down.
User, Installations and Maintenance Manual
24
5
17
4
A
23
3
8
2
1