Getting Started - Labelmate MC-11 Bedienungsanleitung

Getting started

3
4
• Slide the cardboard core all the way up against the Flange Plate.
• Pull the label web to the cardboard core and use a piece of tape to secure the label web.
• Adjust the position of the MC 11 if necessary so it is square with the label path.
• If you are using the APG MC Adjustable Paper Guide, move the Arm into position to guide the outer edge of the labels
and lock it into place.
• Place the MC 11 (ON OFF ON Direction) Switch to the ON position in the desired direction of operation, left or right.
• Start the printer a nd observe that the labels are being rewound correctly. You can adjust the speed/torque by turning
the potentiometer on the upper part of the machine to p rovide more or less rewind force as desired.
• When rewinding is finished, place the MC 11 (ON OFF ON Direction) Switch to the OFF (0) position.
• If the APG MC Adjustable Paper Guide is in use, unlock and move the Arm out of the way.
• Slide the cardboard core and the wound labels off the MC 11. You do not need to loosen the three (3) Locking Levers
unless y ou want to use a different diameter core.
EXTERNAL CONTROL, ONLY FOR + MODEL
The MC+ can be controlled by the printer. A 3.5mm (mono) con-
nector for an External Control Input (start/stop) is provided and a
matching jack is enclosed. The MC+ can react to different types
of signals provided by the printer. The selection of the signal na-
ture is done via 2 jumpers on the MC+ internal PCB. Four modes
are selectable: Open Collector High Active, Open Collector Low
Active, Logic Level High Active (Max 10VDC) & Logic Level Low
Active (Max 10VDC).
The factory setting is "Open Collector high". Other default setting
on request.
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
• 1- REWIND FINGERS (3P)
• 2- LOCKING LEVER (3P)
• 3- SPEED SELECTOR
• 4- INNER-FLANGE
2
• 5- ON/OFF/DIRECTION
SWITCH
1 • 6- EXTERNAL HALT on MC-+
model only
6
SIG ACT LOW
SIG ACT HIGH
OPEN COL LOW
OPEN COL HIGH
5
JP2 JP3
1
2
x 1
x 2