Important Notice - Labelmate MC-11 Bedienungsanleitung

About your rewinder
LABELMATE MINI-CAT REWINDERS MC-11 and MC-11 +
winders to be used in combination with small desktop or mid-range barcode printers. With a specially designed bi-direc-
tional motor, they offer trouble-free performance for many years at an incredible low cost.
FEATURES
• Maximum Label Roll Weight: 3 KG
• Maximum Label Width: 125 mm
• Maximum Roll Diameter: 220 mm
• Maximum Speed: 50 CM/SEC at the beginning of a 76 mm core roll
• An external command interface on the '+' models to support direct control start/stop by the barcode printer (check
compatibility with your printer vendor). The MC+ can react to different types of signals provided by the printer. Please
note that Labelmate does not provide custom build cables to specific printer models/interfaces.
DIMENSIONS
• W x D x H: 220 x 305 x 195 mm
• Weight: 5.6 KG

IMPORTANT NOTICE

• Remove all parts from the shipping container and verify contents.
• User Manual (this document)
• Label Rewinder Unit
• Power Supply Module
• Retain the Shipping Container and Packaging for Storage and Transport
SET-UP
• Place the MC-11 so that the three (3) Rewind Fingers are pendicular to the web of the labels to be rewound. The MC-11
is bi-directional, so can be operated in either direction.
• Verify that the (ON/OFF/ON) Switch on the rear of the Unit is in the OFF (0) position.
• Insert the Power Cord into the Power Socket on the rear of the MC-11.
• Plug the AC/DC Adapter into a suitable electrical outlet. It can be left plugged in at all times.
• The MC-11 has a combination Power and Direction (ON/OFF/ON Direction) Switch on the Rear Panel. The Centre Po-
sition of the Switch is "OFF" (0). To make the Rewinder run to the right (looking from the rear of the Rewinder), press
the Power / Direction Switch in the direction of the right arrow. To make the Rewinder run to the left, press the Power /
Direction Switch in the direction of the left arrow.
REWINDING ON A CARDBOARD CORE
• Loosen the three (3) black Lock Levers on the back of the Core Holder Flange Plate.
• Grasp the front Flange Plate with one hand and the rear Flange Plate with the other. Notice the rear Flange Plate has
convenient cut outs for your thumb.
• Rotate the Plates in opposite directions until the three (3) Core Fingers move to the cent re next to each other.
• Slide an empty cardboard core over the Fingers till close to the Flange Plate.
• Now rotate the Flange plates in the opposite direction to expand the Fingers against the inside of the cardboard core.
While you hold the Flanges so the Fingers are tight against the inside of the Core, move one of the Locking Levers to the
LOCK position. NOTE: If one or more of the Locking Levers is up against the Hub and won't lock, pull up on the Lever
(away from the Flange Plate) and reposition it.
• Now move the other two (2) Locking Levers to the LOCK position.
are the world´s most popular entry-level label re-
GENERAL
• Power Supply: 220-240VAC- 50-60Hz., Output 15VDC
• Limited Warranty of 5 Years, 1 Year on the Power Supply
Labelmate.com