Contact Information - LAS 11807 Bedienungsanleitung

CAUTION
IT IS VITAL TO MIND THE SAFETY INSTRUCTIONS!
• When loading your drawbar carrier, it is vital to follow the maximum
loading capacity of your towbar. Attention: the steering angle must not
be hindered.
• The profi le width of the caravan drawbar must not exceed 45 mm.
• Caution: The steering lock must not be impeded.
• The assembly and the attachment of the drawbar carrier are only
correct when the distance between the drawbar profi les is between
380 mm-740 mm.
• The required minimum length of the drawbar is 1400 mm (see photo).
• The drawbar carrier is not suitable for installation on short drawbars.
• Prior to each departure and also in between your trip check if the carrier is
fi xed tightly on your drawbar and also check the fastening of your bicycles
on the drawbar carrier, to recognize possible damages of the fastening
parts at an early stage and repair it.
• If loaded the safety strap has to be installed.
• In case of cross winds lower your speed. Take care that no attachment
parts on the bicycle can get lost (bicycle tyre infl ator, baskets, bicycle bell
etc.). Avoid jerky braking, acceleration and steering movements. Only use
original parts for exchange.
• For correct and secure mounting follow the assembly instructions exactly.
In case of doubt of these instruc-tions contact the dealer or the
manufacturer directly for further information.
• For your own safety you should check the carrier and the corresponding
load at regular intervals, as you are obliged to do so according to § 23 of
the Road Traffi c Regulations and in case of any damage you can be hold
liable.
• The manufacturer and the dealer absolve themselves of responsibility
for any damages to property or persons based on incorrect mounting or
improper use
• The product was checked also tested under extreme conditions, whereas
good results were achieved in regard to safety and stability. When
installed correctly we can exclude any malfunction.
This drawbar carrier was checked for completeness. The aluminium
drawbar carrier has a dead weight of approx. 4 kg without fastening parts
and approx. 6 kg with fastening parts. The fastening parts are made of
stainless steel and plastics !

CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
9