Technical Data; Assembly Instructions - LAS 11807 Bedienungsanleitung

TOWBAR RACK
CONTENTS
TECHNICAL DATA _________________________________7
ASSEMBLY INSTRUCTIONS ___________________________7
U-BOLT FASTENINGS _______________________________8
FASTEN BICYCLES ON THE DRAWBAR CARRIER _______________8
CONTACT INFORMATION ____________________________9
EXPLODED VIEW _________________________________2
WARNING
Please read the operating instructions carefully prior
to use and observe all safety instructions!
Retain the original packaging, the proof of purchase
as well as these instructions for subsequent reference!
When passing on the rack, please include these opera-
ting instructions as well. Not observing such may lead
to personal injury, damage to the device or to your
property! Please check content of package for integri-
ty and completeness prior to use!
Before you start with the mounting process, check completeness of the
drawbar carrier and read assembly instructions carefully. It is vital to follow
the safety instructions. Please keep in mind that some parts listed on the
parts list are already pre-assembled. Technical subject to change.

TECHNICAL DATA

Max. loading capacity: 35 kg
Dead weight: approx. 6 kg

ASSEMBLY INSTRUCTIONS

Picture 1
REQUIRED PARTS
Wheel rails
Wheel rail fastenings
Rail gap: approx. 15 cm
Max. tyre width up to 2.35 inches
Belt guides
Basic frame
Start with the preparation of the wheel rails. Shove 2 slot nut screws
M6 x 50 each into the link under the wheel rail. At 2 rails insert 1 belt guide
and at the both other rails 2 belt guides also in the link.
Put the wheel rail end caps on both ends of the wheel rails. Now position the
wheel rails on the basic frame and slide the thread of the slot nut screws into
the provided boreholes of the basic frame and secure them with the 6 mm
washers and the plastic toggle nuts. Please consider, that 1 wheel rail each
with one, respectively with 2 belt guides make one wheel unit. (2 belts for
the front wheel and one for the rear wheel) The belt guides point to the
outsides. The wheel rails can be adjusted easily after loosening the toggle
nuts.
Picture 2
REQUIRED PARTS
U BOLT
Wheel rail end caps
Boreholes
7