Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL TE-TC 18/115 Li-Solo Originalbetriebsanleitung

•
Place the tile with its glazed side on the water
container cover (Fig. 15).
•
Fig. 15 shows the correct position for your
hands during the miter cut. Your left hand
holds the workpiece in contact with the cutting
wheel while your right hand pushes the work-
piece forward. The feed rate must not exceed
the cutting capacity of the cutting wheel. This
is to make sure that no material becomes
detached, as this might cause accidents or
injuries.
•
Carry out a trial cut with a spare tile so that
you can check the results of the cutting.
Important! If the cutting wheel becomes jammed,
switch off the equipment and take out the battery;
only then are you to remove the workpiece.
10. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
Take out the rechargeable battery each time be-
fore carrying out any adjustments, maintenance
or repairs.
10.1 Cleaning
•
Keep all safety devices, air vents and the mo-
tor housing free of dirt and dust as far as pos-
sible. Wipe the equipment with a clean cloth
or blow it with compressed air at low pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
10.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
10.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_TE_TC_18_115_Li_SPK13.indb 22 Anl_TE_TC_18_115_Li_SPK13.indb 22
GB

10.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

11. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
12. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30 °C. Store the electric tool
in its original packaging.
13. Transport
If you want to move the equipment to a diff erent
place, take out the battery fi rst and then move the
equipment to the new position.
- 22 -
12.08.2021 16:47:07 12.08.2021 16:47:07