Gastros Switzerland InductWarm 130+ Undercounter Betriebs- Und Montageanleitung Seite 28

Connectors
The
BUS, network and USB connections are located on the underside of the InductWarm
Connection external
control panel
BUS coupling / network mode
If a certain number of InductWarm
network must be connected to an external control panel and connected via BUS cable to any other unit within the
network. When the ON/OFF button of the external control panel is pushed, the connected unit becomes the
"master" of the network. All other units become "slaves".
Slave 1
z.B. Address «2»
Every 3 seconds, the "master" unit sends information to the "slave" units. When running in network mode, the
units can only be operated on the same power level. It is not possible to control each unit individually.
Note: Valid "AutoPowerOff" time for the entire network is the time set within the "master" device (default 600s).
To run the units in a network, each device must have an individual device address! When ordering
the devices, please specify how the devices are to be operated.
If there is no dish detected on any of the units in the network, all units will automatically go into standby mode
after 20 seconds. In network mode, dish detection is not shown by flashing power level buttons. Up to 16
InductWarm 130+ units can be linked with a BUS network cable.
®
28
USB connection
130+ units should be operated within a network, one chosen unit of the
®
Master
z.B. Address «5»
InductWarm
BUS
Slave 2
z.B. Address «3»
130+ unit:
®
®
Slave 3
z.B. Address «4»