Dmx Operation - EuroLite LED Strobe SMD PRO 864 DMX RGB Bedienungsanleitung

Manual Settings
Manual
Device
Info
Information
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Set the DMX address to A001 for all slave
devices. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode (under Run Mode: Auto oder Sond). The
interconnected devices will now operate in synchronously.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 54 control channels.
However, it can also be switched to a mode with 5 or 13 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MUSE button so many times until Address is indicated on the display. Confirm with the
ENTER button.
2 Now the display indicates the menu item for the DMX start address 001-512. Use the buttons UP and
DOWN to set the address. Confirm with the ENTER button.
3 Now press the UP button so many times until Channel is indicated on the display. The display indicates
the menu item for the DMX channel modes: 5CH (5 DMX channels), 13CH (13 DMX channels) or 54CH
(54 DMX channels). Confirm with the ENTER button. Use the buttons UP and DOWN to select the
desired DMX channel mode. Confirm with the ENTER button.
4 A dot will light up when DMX signals are being received. If no control signals are available, the dot will
flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Dimmer 000-255
Strobe 000-255
Red 000-255
Green 000-255
Blue 000-255
White 000-255)
RunTime 0000-9999
Tempera XXX
DivVers V0.01
23/28
Brightness, increasing
Flash rate, increasing
Red, increasing intensity
Green, increasing intensity
Blue, increasing intensity
White, increasing intensity
Operating hours of the device
Inner temperature
Software version
00134564, Version 1.1