Cadac Safari Chef 30 Compact Bedienungsanleitung Seite 4

How to check the appliance is connected to the gas cartridge in a sound fashion.
• The correct way is to smear the joints e.g. where the cartridge screws onto the appliance, with
soapy water.
• If bubbles form, then there is a gas leak. Immediately remove the gas cartridge from the
appliance. Check that all the connections are properly fitted. Check that the seal is in place and
in good condition before connecting a gas cartridge (Fig. 3c). Re-check with soapy water after
refitting the cartridge.
• If a gas leak persists, return the product to your CADAC dealer for inspection / repair.
• If the cartridge is automatically ejected from the regulator, do not attempt to reconnect the
cartridge.
• When using a pot, the minimum recommended pot size is 180mm and maximum pot size is
250mm.
• For outdoor use only!
3. Fitting and Changing the Gas Supply
Connecting the cartridge
• Open the cartridge cover (see section 4 for list of components).
• Check that the control knob is in the "off" position and that the lever is set to "unlock" (see Fig.
1).
• Note! The cartridge can only be locked if the control knob is in the "off" position.
• Check that the seal (Fig. 3c) is in place and is in good condition before connecting the cartridge.
• Do not use the appliance if it has a damaged or worn seal.
• Do not use an appliance which is leaking, damaged or which does not operate properly.
• Connect the cartridge in a horizontal position and ensure that the notch is in line with the safety
guide (as shown in Fig. 3d).
• CAUTION: Ensure that the notch is facing upwards and that the safety guide is inserted in the
notch.
• Lock the cartridge into place by moving the lever to the "lock gas" position (see Fig. 1).
• CAUTION: If you smell gas, refer to section 2 on how to check for a gas leak.
Disconnecting and changing the cartridge
• Before disconnecting the cartridge, check that the burner is extinguished and that the control knob is in the "off position".
• Unlock the cartridge by moving the lever to the "unlock" position (see Fig. 1).
• Open the cartridge cover and remove the cartridge in a horizontal position (as shown in Fig. 3b).
• Note! The cartridge can be removed even if it is not empty and can be stored to be used for another time.
• Change the gas cartridge in a well ventilated area, preferably outdoors and away from any source of ignition suck as naked flames, pilots,
electric fires and away from other people.
• To refit a previously used gas cartridge, refer to instructions above on how to connect the cartridge. Apply the same care and checking
procedures as if fitting a new gas cartridge.
• Be careful, the gas cartridge could be hot, allow the cartridge to cool before removing. Check the seal before connecting a new gas
cartridge.
Fig. 3a
Seal
Notch
Fig. 3c
2 2
Fig. 3b
Fig. 3d
Safety Guide
EN
Fig. 1
Fig. 2