Safety Instructions - Omnitronic TRM-422 Bedienungsanleitung

2 Safety Instructions

Keep this device away from rain and moisture!
Be careful with your operations. With a dangerous voltage you can suffer a dangerous electric
shock when touching the wires!
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems.
Intended Use
• This device is used to mix line and phone signal
sources. It has been specially designed for DJs.
Unpacking
• Please make sure that there are no obvious
transport damages. Should you notice any
damages, do not take the device into operation
and immediately consult your local dealer.
• Save the package and all packing materials. In
the event that a fixture must be returned to the
factory, it is important that the fixture be returned
in the original factory box and packing.
Protection Class
• This device falls under protection class I. The
power plug must only be plugged into a
protection class I outlet. The voltage and
frequency must exactly be the same as stated
on the device. Wrong voltages or power outlets
can lead to the destruction of the device and to
mortal electrical shock.
Power Cord
• Always plug in the power plug least. The power
plug must always be inserted without force.
Make sure that the plug is tightly connected with
the outlet.
• Never let the power cord come into contact with
other cables! Handle the power cord and all
connections with the mains with particular
caution! Never touch them with wet hands, as
this could lead to mortal electrical shock.
• Never modify, bend, strain mechanically, put
pressure on, pull or heat up the power cord.
Never operate next to sources of heat or cold.
Disregard can lead to power cord damages, fire
or mortal electrical shock.
• The cable insert or the female part in the device
must never be strained. There must always be
sufficient cable to the device. Otherwise, the
cable may be damaged which may lead to
mortal damage.
• Make sure that the power cord is never crimped
or damaged by sharp edges. Check the device
and the power cord from time to time.
CAUTION!
CAUTION!
The occupation of the connection cables is as
follows:
Cable
Brown
Blue
Yellow/Green Earth
The earth has to be connected! If the device will
be directly connected with the local power
supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to
be included
installation. The device must only be connected
with an electric installation carried out in
compliance with the IEC standards. The electric
installation must be equipped with a Residual
Current Device.
Liquids
• There must never enter any liquid into power
outlets, extension cords or any holes in the
housing of the device. If you suppose that also a
minimal amount of liquid may have entered the
device, it must immediately be disconnected.
This is also valid, if the device was exposed to
high humidity. Also if the device is still running,
the device must be checked by a specialist if the
liquid has reduced any insulation. Reduced
insulation can cause mortal electrical shock.
Foreign Objects
• There must never be any objects entering into
the device. This is especially valid for metal
parts. If any metal parts like staples or coarse
metal chips enter into the device, the device
must be
disconnected immediately. Malfunction or short-
circuits caused by metal parts may cause mortal
injuries.
12 • EN
Pin International
Live L
Neutral N
in the permanent
taken out of operation
electrical
and