CONDTROL XLiner 360 G Bedienungsanleitung Seite 10

EN
CROSS LINE LASER
Short press button
working with laser receiver. In this mode pulse mode indicator will
turn red.
To switch the laser level off short press button
until all laser planes are off.
Attention! To increase operating time and avoid the risk of
unintentional blindness switch the laser on only when you are ready
to work.
If operated near objects or air streams with the temperature different
from the environment the laser line may tremble due to heterogeneity
of the atmosphere. The longer the distance, the more trembling of the
laser line can be observed.
The width of the laser line increases as soon as operating distance
increases as well. The layout should be made along the axis of the laser
line. For maximum accuracy, use the middle portion of the laser line.
It should be noted that the shape of the laser line on the object's
surface (e.g., walls, ceilings, etc.) depends on the curvature and tilt of
the surface relative to the laser plane.
Bluetooth
Bluetooth is always on by default.
Switch on the laser level. Activate Bluetooth at your portable device
and start the app "XLiner Remote". Perform connection via Bluetooth.
The app allows switching on and off the laser lines and dots, receiver
mode, as well as adjust the brightness of the laser for optimal visibility
and energy saving and control the battery charge level without
touching the laser level.
10 10
XLiner 360 G / COMBO 360 G
to switch on/off pulse mode that allows
user manual
several times