Interface Rs232C; Data Transfer Mode; Baud Rate - KERN PCB Serie Betriebsanleitung

8.5 Interface RS232C

Data output via interface RS 232 C
General Information
The previous condition for the data transfer between balance and a peripherical
device (e.g. printer, PC ...) is that the appliances are set to the same interface
parameters (e.g. baud rate, transfer mode ...).

8.5.1 Data transfer mode

Setting of data transfer mode
1. Keep the key pressed until „Unit" is displayed.
2. Press key, „Pr" appears.
3. To change the setting, press the
4. The mode can be converted using the
(Pr PC; AU PC; AU Pr ; re Cr ; BA Pr ;details chapter 9.4).
5. The changed setting is taken over by pressing the
6. The balance returns to the weighing mode.

8.5.2 Baud rate

The baud rate necessary for the measuring values transfer can be set.
In the following example the baud rate is set to 9600 baud.
Setting of baud rate
1. Keep the key pressed until „Unit" is displayed.
2. Press key
3. Press key, „baud" appears.
4. Confirm by pressing the
5. The baud rate can be changed using the
2400, 4800, 9600, 19200).
6. The changed setting is taken over by pressing the
7. The balance returns to the weighing mode.
26
key.
key
key.
key (1200,
Balance display
Unit
Pr
Pr PC
AU Pr
key.
0.0 g
Balance display
Unit
Pr
Baud
4800
9600
key.
0.0 g
PCB-BA-e-0712