Merax MS195414 Bedienungsanleitung Seite 23

2. Remove the preinstalled screws M8*22. Use 5# hexagon wrench and screw M6*12 to lock and
fix the base (two screws for each side). Then install the screw M8*22 back.
M8*22
M6*12
3. Hold left& right columns, use 6# hexagon wrench and screw M8*25 to lock the console frame
on the columns (Tighten all screws in above steps, and please notice not to clamp the cable by
column).
Screw M8*25
4. Use the plum knob to lock the main base and columns (Rotate clockwise, please refer to the
arrow point direction). Uneven ground may cause trouble when rotate the knob, please lift the
column slightly to left side (as shown below). In order to fold the machine easily next time, please
DON'T rotate the knob too tight.
6