Adjusting The Self-Propel Drive - Toro Super Recycler 21690 Bedienungsanleitung

Figure 32
4. Remove the blade, saving all mounting hardware
(Figure 32).
5. Install the new blade and all mounting hardware
(Figure 33).
Figure 33
Important:
Position the curved ends of the
blade to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt
to 82 N∙m (60 ft-lb).
Important:
A bolt torqued to 82 N∙m (60
ft-lb) is very tight. While holding the blade
with a block of wood, put your weight
behind the ratchet or wrench and tighten the
All manuals and user guides at all-guides.com
Adjusting the Self-Propel
Drive
For Self-Propel-Drive Models Only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
g231389
g231390
27
bolt securely. This bolt is very difficult to
overtighten.
1. Turn the adjustment nut counterclockwise to
loosen the cable adjustment
Figure 34
1. Handle (left side)
2. Adjustment nut
3. Self-propel-drive cable
2. Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the engine to
increase the traction; pull the cable away from
the engine to decrease the traction.
3. Turn the adjustment nut clockwise to tighten the
cable adjustment.
Note:
Tighten the nut firmly with a socket or
wrench.
(Figure 34).
g269307
4. Turn the nut clockwise to
tighten the adjustment.
5. Turn the nut
counterclockwise to
loosen the adjustment.
(Figure 34) by