Control Panel Description; Electrical Connection - Whirlpool WBC3547ANFX Bedienungsanleitung

A. Refrigerator Compartment
2. Lighting
3. Shelves / Shelf area
4. Multi-flow cold air system
5. Cooler compartment
6. Rating plate with commercial name
8. Crisper divider
9. Reversibility kit
10. Egg tray
11. Separator
12. Door trays
B. Freezer Compartment
13. Storage baskets for frozen food items
14. Shelves
15. Middle basket (freezing zone)
16. Ice tray and/or cold accumulator
18. The freezer door trays for pizza or other frozen products
with a short storage time
Depending on the model the number and type of accessories
may vary.
The freezer compartment can be used without the two upper
baskets to increase storage for large products. The lower basket
must not be removed.
Place the food products directly on the racks.
After inserting food, ensure that the freezer compartment door
closes properly.
C. Control panel
Anti-bacterial protection:
1. Filter in fan (depending on the model)
7. Crisper with antibacterial additives (depending on the
model)
17. Door seals
The crisper and the door seals are manufactured from
materials that inhibit bacterial growth.
Notes:
- In case of power failure the cold accumulator helps to
keep optimal storage temperature longer.
- All shelves and door trays are removable.
- The internal temperatures of the appliance depend on
the ambient temperature, frequency of opening the doors, as
well as location of the appliance. Temperature setting must
consider these factors.
- The appliance accessories are not suitable for washing
in dishwasher.
D GB F
PRODUCT SHEET
NL E P I GR
FAN WITH A BUTTON
The fan gives more even temperature distribution inside the
refrigerator compartment, allowing better preservation of stored
food. To switch on the fan press the button (1a). It is advisable to
activate the fan when the ambient air temperature is over 27 ÷
28°C or if you perceive drops of water on the glass shelves or in
the severe humidity conditions.
Note:
Do not obstruct the air intake area with food items.
The fan will run ONLY when the compressor is in
operation.
Remember to turn off the fan when there is a lower
ambient air temperature.
If the appliance has the fan it can be equipped with the
antibacterial filter.
Remove it from the box (found in the crisper drawer (item 7)
and insert into the cover of fan (item 1b).
The replacement procedure is attached with the filter.

CONTROL PANEL DESCRIPTION

Compartments ON/OFF, menu, selection and confirmation
buttons
1. Refrigerator compartment Stand-by button
2. Menu button
3. Appliance ON/OFF button
4. Selected compartment temperature increase button
5. Confirmation button
6. Selected compartment temperature decrease button.
Switching on the appliance: Press & hold for 3 sec. the
"On-Off" button to activate freezer compartment and
then press & hold for 3 sec. the " fridge stand-by" button
to activate refrigerator compartment.
Switching off the appliance: Press & hold for 3 sec. the "On-
Off" button again.
Adjusting the temperature: To change the temperature inside
the refrigerator or freezer compartment, press the Menu button
until the refrigerator or freezer temperature symbol flashes).
Then adjust the temperature by pressing the +/- buttons and
confirm by pressing "OK".
Displaying the refrigerator and freezer compartment
temperatures.
The temperature inside the refrigerator compartment can be
adjusted between +2°C and + 8°C. In the same way, the
freezer compartment temperature can be adjusted between
-16°C and -24°C.

ELECTRICAL CONNECTION

When the appliance is connected to the power supply, the
display lights up and all the symbols appear on the display for a
few seconds.
The freezer factory setting -18°C appears and flashes, while the
refrigerator display shows a temperature of +5°C (factory-set).
S N DK FIN PL CZ SK H RUS BG
GB
RO