Operating Yourwine Cooler - Climadiff Avintage AV7XK Gebrauchsanweisung

1. Remove the ventilation grille ○ ,2 and the adjustable ventilation grille ○ ,1 by unscrewing the screws ○ ,3 & ○ ,4. (Fig. 1)
NOTE: For some models without adjustable ventilation grille, the step is not needed.
2. Remove the bottom hinge ○ ,5 by unscrewing the four lock screws ○ ,6. Be careful to hold the glass door firmly after
removing the screws. (Fig. 2)
3. Gently pull down to remove the glass door from the right top hinge and place it on a padded surface to avoid the risk of
damage. Then remove the right top hinge ○ ,9. (Fig. 4)
4. Unscrew and transfer hinge pin ○ ,7 and/or door stopper ○ ,8of the bottom hinge to the opposite side. (Fig. 3)
5. Pop out the cover caps on the left side of cabinet and use them to
6. Screw the alternative left top hinge ○ ,11, included in the fittings,
7. Unscrew and transfer the holes cover ○ ,12 and lock catch ○ ,13 to the opposite side of glass door. (Only for models with
lock on the ventilation grille) (Fig. 5)
8. Rotate the door 180° (No need for models with lock on the door) and relocate the door to the designated position. Then
screw the bottom hinge assembly on the left designated position and tighten it after the door is leveled.
9. Transfer the handles & plugs to the opposite positions and then reassembly the ventilation grilles if need.

OPERATING YOURWINE COOLER

The Wine Cooler should be placed in a position where the ambient temperature is between 16-38°C/60~100ºF. If the
ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your
unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The range of 5-22°C/40-72ºF may not be
reached.
Note:
When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut off for a long time, there could be
a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to
the length of the activation time. Once the Wine Cooler is running for a few hours everything will be back to normal.
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the Wine Cooler will not start.
THE CONTROLS OF YOUR WINE CELLAR
MODEL 1 ZONE
All manuals and user guides at all-guides.com
cover the screw holes on the right hand side.
on the left hand side of cabinet. (Fig. 4)
31