Initial Use; Operation - auna Silver Star Swing Bedienungsanleitung

EN

INITIAL USE

Before operation, please make sure that the VOLTAGE mentioned on the
power supply is same as the voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains
socket.
When it is the first time running the device, the setup wizard is launched
automatically.
Press Standby button when unit is power on, unit will go to standby mode.
Press again will make it on again.
Setup wizard
When radio is started for the first time, it runs through a setup wizard to
configure settings for date/time and network. Once this has finished, the
system is ready to use in most modes.
Note: To change these settings later, select Menu>System settings>and
select the required settings options. To run the setup wizard again, select
Menu>System settings>Setup wizard
The Setup wizard guides you through the basic setup parameters for Time/
Date and Network connection. To change any settings later all setting
functions are accessible from the Settings Menu.

OPERATION

After the initial setup, radio is ready for operating in most Modes.
Mode selection
From the Main Menu select a mode and press OK. Alternatively press Mode
button repeatedly to switch to different mode. After a brief moment radio
switches to that mode. The last station or track previously used in that
mode is selected. If this is not possible, radio scans for relevant stations,
networks, or prompts the user for appropriate input.
Audio playback
The common local controls for audio playback are available in all listening
modes:
The general track controls are Play/Pause to start and stop tracks and
the Next and Previous buttons to skip to the next or previous track in the
current playlist.
44