Precautions For Use; Installation - auna 10004779 Handbuch

INSTALLATION

 UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
 DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAIN VOLTAGE AND BEFORE
ALL OTHER CONNECTIONS HAVE BEEN MADE.
 DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
FOR TABLE TOP USE
INSET THE STAND TO THE MAIN UNIT AND
THE PICTURE
FOR WALL MOUNTING
1) UN-INSTALL SPEAKER BOX AND THE STAND IN THE REVISE WAY FROM ABOVE
2) USE THE WALL-MOUNTING TEMPLATE SUPPLIED WITH THE UNIT TO MAKE ANCHOR HOLE MARKS
ON THE WALL. MAKE SURE THE MARKS ARE LEVEL.
3) DRILL 1/4" HOLES ON THE MARKS.
4) INSERT THE PLASTIC ANCHOR SUPPLIED WITH UNIT IT IS FLUSH WITH THE WALL.
5) INSERT THE SCREW AND TIGHTEN THE SCREW 4MM AWAY FROM THE WALL. (APPROXIMATELY
THE WIDTH OF 2 PENNIES) HANG THE MAIN UNIT AND SPEAKERS TO THE SCREW AS INDICATED
BELOW:-
1. CONNECT THE POWER CORD (22) TO AC OUTLET
2. WHEN YOU FIRST PLUG THE UNIT INTO THE MAINS, THE UNIT WILL GO INTO STANDBY MODE
AND THE STANDBY LED INDICATOR (3) WILL LIGHT UP.
3. CONNECT THE SPEAKER WIRE TO THE SPEAKER JCK (21) LOCATED ON THE SIDE OF UNIT.
4. TURN ON THE POWER (5), IF THE LCD DISPLAY (4) IS ON WITH BACKLIGHTING, IT MEANS THE
POWER SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.

PRECAUTIONS FOR USE

INSTALLATION
CONNECTION
SPEAKER BOX REFER TO