Kinderkraft XPAND Bedienungsanleitung Seite 27

Securing the vehicle
In certain vehicles, the seat fabric may be made of frail materials, which the booster seat may
ruin. You can avoid this by placing a blanket or towel under the booster seat.
5.1 Installing the booster seat for children in weight groups ll/lll with the 3-point safety
belt.
IMPORTANT: You will find the locations of ISOFIX and top tether points and other important
information concerning installation of the booster seat in your vehicle in the vehicle's
instruction manual. You MUST read the manual.
• Adjust the headrest appropriately to the child's height (see point 4.1).
• Place the booster seat on the car seat. Make sure that the booster seat backrest is flat
against the car seat backrest (see point 4.2).
• Slide the shoulder strap through the red guide (F) under the headrest.
• Place the child in the booster seat and run the car seatbelt in front of the child. Lock the car
seatbelt to hear a characteristic "click".
• The hip and shoulder straps should run under the armrest through the hip strap guides (H).
Tighten the car seatbelt by pulling first the hip strap segment and then the shoulder strap
segment. Make sure that the hip strap stretches possibly low above the child's hips, fits in
the guides, and is locked with the buckle. The shoulder strap should run between the child's
shoulder and neck. Make sure that the strap is not too tight on the child's neck.
Recommendation! You can change the headrest height when the booster seat is installed in
the vehicle.
5.2 Installing the booster seat for children in weight groups ll/lll with the 3-point safety belt
and additional tethers.
• Turn the ISOFIX anchorages under the seat, towards the back of the seat.
• Grab the booster seat with both hands and slide both tethers into the anchors of the car
seat until you hear a "click".
• ATTENTION! The tethers are is proper place only when both button markers are completely
green.
• Grab the booster seat and check if it is not loose. If it moves and the ISOFIX tethers come
out, repeat the steps presented above.
• Buckle the child in with the car seatbelt. For details, please see the part covering the booster
seat installation for weight groups II and III (point 5.1).
5.3 Removing the booster seat (ISOFIX)
• Press the ISOFIX release button on both ISOFIX arms (I). The anchorages will be released
and the marker colour will change to red. Hide the ISOFIX anchorages into the seat base.
6.1 Installing/removing the cover
• Removing the backrest cover: Detach the four fasteners fixing the cover to the back of the
seat backrest. Remove the cover from the side guards.
• Removing the headrest cover: Detach the fasteners on the back of the cover and remove it
from the headrest.
27