Kinderkraft SAFETY FIX Bedienungsanleitung Seite 32

5.4 Installing the car safety seat in weight groups 2 and 3 using the safety belt and extra
anchorages.
• Pull out the ISOFIX anchorages and put them in the ISOFIX attachment points until you hear
a "click".
• Press the ISOFIX release button (S) and pull out the ISOFIX attachments (P) as far as possible.
• Grab the seat with both hands and push the two fixing hooks in the back seat.
• When you hear the "click" of each ISOFIX hook, push the seat to the back seat, exerting
strong, even pressure on both sides.
• Grab the safety seat and make sure it is securely fastened without play. If it moves and
ISOFIX attachments slip out, repeat the previous steps.
• Fasten your child using the vehicle seat belts. Details are described in the section of the
safety seat installation instructions for weight groups 2 and 3 (see sections 5.2 and 5.3).
6.1 Removing 5-point harness with cover
• Pull the harness straps out of the metal buckle.
• Pull the crossbar that holds the shoulder belts through the groove in the shell.
• Pull the shoulder belts out through the holes in the backrest.
• Pull the belt hooks through the holes in bottom of the seat.
• Disassemble the plastic cover on the underside of the seat by unscrewing the screws.
• Remove the crotch belt buckle through the hole in bottom of the seat, then re-assemble the
plastic cover with the screws.
• Then remove the cover from the headrest and the seat shell.
6.2 Installing 5-point harness and cover
• After cleaning, place the cover on the shell and the headrest of the seat. Pull the cover over
the seat. Fasten the latches on the back.
• Pull the belt latches through the holes in the seat.
• Pull the crotch belt buckle (J) through the hole in the seat.
• Pull shoulder pad straps through the holes in the seat back.
• Pull the metal crossbar through the ends of the shoulder belt pads. Lock the crossbar by
placing it in the seat shell.
• Pull the ends of the harness straps through holes in the seat back (as for the shoulder strap
pads). Harness straps must pass over the metal crossbar.
Then secure the ends of the harness straps in the metal buckle.
• Close the buckle (J), and then check that the harness straps are not twisted.
6.3 Cleaning
Use the original cover only, since they are essential for the safety of the seat.
NOTE Do not use the seat without the cover.
• The cover can be removed and washed in mild powder using delicate washing program
(30°C). Observe the washing instructions on the label placed on the cover. In the case of
washing at a temperature above 30°C the colour may fade. The cover may not be spun or
tumble dried (which can lead to separation of the material from the lining of the pad).
32