Herunterladen Diese Seite drucken

Kinderkraft SAFETY FIX Bedienungsanleitung Seite 29

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
with retractor approved according to UN/ECE Regulation No. 16 or other equivalent
standards.
• Note that any straps attaching the child seat to the vehicle must be tight; the restraint
harness must fit the child's body and the belt/harness must not be twisted.
• The seat should be replaced if it has been subjected to violent stresses in an accident.
• The seat must not be subject to any modifications.
• The child safety seat should be protected from direct sunlight, otherwise heated parts can
burn your child.
• Never leave your child in the seat unattended.
• It should be noted that any bags and other items must be sufficiently secured, in particular
on the parcel shelf, as otherwise in the event of a collision this can lead to injury.
• The seat cannot be used without the cover.
• Do not use replacement covers other than those recommended by the manufacturer, since
it is an integral part of the safety seat.
• It is recommended to keep the car seat instruction manual for the entire period of its use.
• Do not use anchorages other than those described in the instruction manual and marked
in the child seat.
• All rigid items and plastic parts of the child seat must be located and installed in such a way
to avoid, under normal operating conditions of the vehicle, blocking by a sliding seat or
vehicle door.
• Regularly check the technical condition of the harness, paying special attention to the
fasteners/holders, seams and adjustment elements.
• Discontinue use of the car seat if its parts are damaged or loosened after an accident.
• In case of an emergency situation, it is important to quickly unfasten the seat belts. This
means that the harness release button is not fully secured; make sure your child knows
that s/he is not allowed to play with the buckle.
• Do not use the seat at home. It is not suitable for home use and it should only be used
when travelling by car.
• The back of the seat must rest flat against the back of the car seat. Please make sure that
the headrest dues not create an unwanted space between the car seat backrest and back
seat of the vehicle. Some car headrests constitute an obstacle to the installation of a car
seat and must therefore be disassembled first.
• The adult safety belt buckle must not be located too close to the bottom of the child seat
armrest. If in doubt about this issue, contact the child seat manufacturer.
• You should give your child a good example and always fasten your belts. An adult with
unfastened safety belts may also be a threat to the child.
• Before each trip by car, make sure that the seat is properly secured.
• The car seat must be protected even when not in use. Unattached seat can cause injuries
to passengers even during emergency braking.
29

Werbung

loading