Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• All passengers fastened their seat belts.
• The safety seat is always protected, even if the child is not in it.
Vehicle security
Seat covers in some vehicles can be made of soft materials so the safety seat may leave some
traces. They can be avoided by placing a blanket or towel under the safety seat.
5.1 Installing the child's seat in weight group 1 (9-18kg) using the ISOFIX child restraint
system and the top tether strap.
IMPORTANT The instruction manual of the vehicle manufacturer specifies the location of the
ISOFIX attachment points and the top tether strap, and other necessary information regarding
the installation of the seat in the car. The user MUST read the instruction manual of the vehicle
manufacturer.
NOTE Make sure that the 5-point harness in the car seat is installed correctly.
• Press the ISOFIX release button (S) and pull out the ISOFIX attachments (P) as far as possible.
• Grab the seat with both hands and push the two fixing hooks in the back seat.
• When you hear the "click" of each ISOFIX hook, push the seat to the back seat, exerting
strong, even pressure on both sides.
• Grab the safety seat and make sure it is securely fastened without play. If it moves and
ISOFIX attachments slip out, repeat the previous steps.
• Remove the top tether strap (N), and press the top tether buckle (M) in order to loosen it.
The strap must be long enough to allow placing the hook (O) in the attachment point in the
back seat.
• Place the top tether hook in the attachment point of the vehicle recommended in the
instruction manual of the vehicle manufacturer.
• Pull the other end of the top tether strap in order to tighten it.
• The upper strap is properly tightened, when the green indicator in buckle (M) is visible.
5.2 Installing the child seat in weight group 2 (15-25kg).
• Before installation, remove the seat harness (see section 6.1).
Remember: Store the cushion, harness, buckle and pads in a safe place for the future.
• Adjust the headrest to the child's height (see section 4.2-2).
• Place the car seat on the vehicle seat.
• Place the shoulder strap in the guide under the headrest.
• Place your child in the seat and place the vehicle belt under the armrest of the seat.
• Fasten your seat belt and make sure you hear a "click".
• Tighten the vehicle seat belt by pulling the first section of the hip belt, and then the shoulder
belt section.
Make sure that the hip belt is stretched as low as possible over the child's hips, placed in the
guides and fixed in the buckle. The shoulder belt should be positioned between the shoulder
and the neck of the child.
5.3 Installing the child seat in weight group 3 (22-36kg).
• Adjust the headrest to the child's height (see section 4.2-2).
• Installation is carried out similarly as in the case of weight group 2.
31
Werbung
