Periods Of Non-Operation; Troubleshooting - Zanussi ZYAN8EW0 Benutzerinformation

About 12 hours prior to defrosting set
a lower temperature in order to build
up sufficient chill reserve in case of
any interruption in operation.
Defrost the freezer compartment when the frost
layer reaches a thickness of about 3-5 mm.
To defrost freezer compartment:
1. Switch off the appliance or pull out electrical
plug from the wall socket.
2. Remove any stored food, wrap it in several
layers of newspaper and put it in a cool place.
CAUTION! A temperature rise of
the frozen food packs during
defrosting may shorten their safe
storage life.
Do not touch frozen goods with
wet hands. Hands can freeze to
the goods.
3. Leave the door open. Protect the floor from the
defrosting water e.g. with a cloth or a flat
vessel.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
The compressor operates con-
tinually.
56
4. In order to speed up the defrosting process,
place a pot of warm water in the freezer
compartment. In addition, remove pieces of ice
that break away before defrosting is complete.
5. When defrosting is complete, dry the interior
thoroughly.
6. Switch on the appliance and close the door.
7. Set the temperature regulator to obtain the
maximum coldness and run the appliance for
three hours using this setting.
Only after this time put the food back into the
freezer compartment.

PERIODS OF NON-OPERATION

When the appliance is not in use for long periods,
take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the door open to prevent unpleasant
smells.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put
in at the same time.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.