End Of Cycle; Daily Use - Drying Only - AEG L77685WD Benutzerinformation

20 www.aeg.com
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pauze - Départ/
Pause.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pauze - Départ/Pause.
The programme or the delay start
continues.

10.13 End of cycle

When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
locked indicator
The indicator of Start/Pauze - Départ/
Pause button goes off.
1. Press button Aan/Uit - Marche/Arrêt
to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
10.14 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:

11. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
All manuals and user guides at all-guides.com
comes on and the door
goes off.
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pauze - Départ/Pause
button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press Aan/Uit - Marche/Arrêt some
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.15 AUTO Stand-by option
The AUTO Stand-by option automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you press Start/Pauze
- Départ/Pause button.
Press the button Aan/Uit - Marche/
Arrêt to activate the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button Aan/Uit - Marche/
Arrêt to activate the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
11.1 Drying setting
WARNING!
is on. The
goes