Starting A Programme; At The End Of Programme - AEG LAVATHERM 75470AH Benutzerinformation

STARTING A PROGRAMME

To activate the programme push the
Start/Pause (Start/Pauze) button. The
LED above the push button changes
the colour to red.
CHANGE A PROGRAMME
To change a programme, push the On/
Off (Aan/Uit) button to deactivate ap-
pliance. Push the On/Off (Aan/Uit) to
activate the appliance and then set the
programme again.

AT THE END OF PROGRAMME

When the drying cycle is completed,
the symbol flashes on the display. If
the Buzzer (Zoemer) function is on, an
acoustic signal sounds intermittently for
one minute.
To remove the laundry:
1. Push the On/Off (Aan/Uit) button
for 2 seconds to deactivate the ap-
pliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
ENGLISH
45