At The End Of Programme; Hints And Tips - AEG LAVATHERM 61270AC Benutzerinformation

70 www.aeg.com
To activate the child lock function push
the Anticrease (Anti-kreuk) and Delay
Start (Startuitstel) buttons at the same
time until the symbol
on the display. To deactivate push again
the above buttons until the symbol go
out of view.
You can activate the child lock function:
• before you push the Start/Pause but-
ton - the appliance cannot start
• after you push the Start/Pause button
- all the push buttons and the pro-
gramme dial are deactivated

7.14 At the end of programme

When the drying cycle is completed, the
symbol flashes on the display. If the

8. HINTS AND TIPS

8.1 Ecological hints
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
8.2 Water hardness and
conductivity
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust the
sensor to dry with the better results.
To change the sensor conductivity:
come into view
Buzzer (Zoemer) function is on, an acous-
tic signal sounds intermittently for one
minute.
To remove the laundry:
1. Push the On/Off (Aan/Uit) button for
2 seconds to deactivate the appli-
ance.
2.
Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Delicate
(Behoedzaam) and Anticrease (Anti-
kreuk) buttons and hold down until
one of the these symbols go into
view on the display:
–
low conductivity <300 μS/
cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600
μS/cm
3. Push the Start Pause button again
and again until you set necessary
level.
4. To memorise setting push at the
same time the Delicate (Behoed-
zaam) and Anticrease (Anti-kreuk)
buttons.
8.3 Water container full —
indication
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED can
be off.
To activate or deactivate the indication: