STEINEL IS 180 Serie Bedienungsanleitung Seite 10

Wiring examples
1. Fixture without neutral conductor
3. Connection via series switch for
manual and automatic operation
1) e.g. 1-4 x 100 W filament bulbs
2) Consumer, lighting max. 1000 W (refer to Technical specifications)
3) Sensor connection terminals
4) Indoor standard switch
5) Indoor series switch, manual, automatic
6) Indoor double-throw switch, automatic, permanent light
Operation/Maintenance
The motion sensor is suit- operation of the sensor.
able for automatic switching Strong gusts of wind, snow,
of lights. The unit is not rain and hail can cause
suitable for special burglary switching errors, since the
alarm systems, since it sudden temperature fluctua-
lacks the sabotage protec- tions cannot be distiguished
tion prescribed for this from heat sources.
purpose. Weather can affect The detection lens can be
18
2. Fixture with neutral conductor
4. Connection to double-throw switch
for permanent light and automatic
operation
Setting I: automatic operation
Setting II: manual operation for permanent
light
Note: the unit cannot be switched off,
only optional operation between settings I
and II.
cleaned with a damp cloth
(without detergents) if dirty.
Troubleshooting
Malfunction Cause
Sensor Fuse has blown, not
without power switched on
Short circuit
Sensor Light threshold in
does not switch ON nighttime mode during
daytime operation
Bulb burnt out
Mains switch OFF
Fuse blown
Detection zone not
properly targeted
Sensor Continued movement
does not switch OFF within the detection zone
Switched on light is with-
in detection zone and
switches on again as a
result of temperature
change
Set to continuous
operation by indoor
series switch
Sensor Switched on light is
keeps switching ON/OFF within detection zone
Animals moving in
detection zone
Sensor Wind is moving trees and
switches on when bushes in the detection
it should not zone
Cars in street are
detected
Sudden temperature
changes due to weather
(wind, rain, snow) or
exhaust air from fans or
open windows
Remedy
Replace fuse, switch on
mains switch, check
wiring with voltage tester
Check connections
Adjust setting
Replace light bulb
Switch power on
Replace fuse, check
connection if necessary
Recalibrate
Check zone and readjust
if necessary or apply
shroud
Readjust zone or apply
shrouds
Series switch to
automatic
Adjust detection zone or
apply shrouds, increase
distance
Adjust zone or apply
shrouds
Blank out areas with
shrouds
Blank out areas with
shrouds
Adjust detection zone or
install in a different place
19