Care And Maintenance; Technical Specifications - Kärcher WD 3 Battery Bedienungsanleitung

Blowing function
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
Note: If it is necessary to remove the suction head when
work is interrupted, the battery pack may become stuck.
The battery pack is locked in tightly and cannot fall out.
Finish operation
 Turn off the appliance.
Illustration
 Push the battery release button forwards and re-
move the battery pack from the device.
 If necessary, recharge battery pack (see chapter
"Charging battery pack").
Recommendation: Remove the battery pack from the
device after completing the work.
Empty the container
Illustration
 Remove the appliance head and empty the reser-
voir.
Storing the appliance
Illustration
 Store the accessories on the appliance and store
the appliance in dry rooms.
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
When transporting by hand
 Lift appliance by the carrying handle and carry it.
When transporting in vehicles
 Secure the appliance against shifting and tipping
over.

Care and maintenance

General care instructions
 Clean the device and accessory parts made of
plastic with a customary plastic cleaner.
 If required, rinse the container and accessories
with water properly and dry them before reuse.
 Check charging contacts for soiling at regular inter-
vals and clean them as necessary.
 Check ventilation slits for soiling and clean them if
necessary.
12
Transport
Cleaning the cartridge filter
Illustration
 If necessary, the cartridge filter can be cleaned un-
der running water. To do this, turn the cartridge fil-
ter in the direction of the symbol to
remove.
Illustration
 Do not rub or scrub the cartridge filter when clean-
ing it.
 Allow the cartridge filter to dry completely before
using it again.
Illustration
 When reinserting, mount the cartridge filter on the
filter basket, turn in the direction of the symbol
and ensure that it is fixed correctly.
Troubleshooting
Appliance is not running
Illustration
 The battery pack is not seated correctly in the bat-
tery holder, insert the battery pack into the battery
holder and let it click into place.
 Charging state of the battery pack (see display) too
low, charge the battery if necessary.
 Defect battery pack or charger, replace battery
pack or charger with new accessory.
The device switches off automatically
 Device/battery pack is overheated, wait briefly to
allow device/battery pack to cool down.
 Container is full of water, which activated the float
tank and empties the container.
Decreasing cleaning power
 Accessories, suction hose or suction pipes are
clogged.
Remove the clog with a suitable aid.
Illustration
 Filter bag is full, install new filter bag.
Illustration
 Cartridge filter is dirty, knock off dirt from cartridge
filter and clean under running water if necessary.
 Replace damaged cartridge filter.
Recommendation: Replace cartridge filter 1x per year.

Technical specifications

Battery pack and quick charger in scope of delivery of:
 WD 3 Battery Set
 WD 3 Battery Premium Set
(Battery pack Battery Power 36/25 / standard charger
Battery Power BC 36 V)
Device
Battery voltage
Rated power
Protective class
Type of protection
Subject to technical modifications!
– 8
EN
unlock and
V 36
W 300
III
IPX4