MPM MOD-50 Bedienungsanleitung Seite 13

Dust bag filling level indicator light (4) turns red when the suction hose is clogged or the dust bag is full. You
need to replace the dust bag or remove the clogging from the suction hose.
5. To ensure optimum appliance setting upon the completion of work, use the guide (6) in the
rear of the vacuum cleaner. Place the rail in the rear of the floor-carpet attachment with con-
nected suction hose and telescopic pipe on the guide. The second guide that facilitates vacu-
um cleaner storage in the vertical position is under the bottom of the appliance.
ACCESSORIES OVERVIEW
FLOOR-CARPET ATTACHMENT
Designed for cleaning large flat surfaces. It is equipped with castors that facilitate movement
in difficult to access places and a flexible joint, connecting it with the suction hose, which
allows directing at various angles. When you press the button on the upper attachment ho-
using (switch it to the brush mode), a row of rigid bristles will appear on the bottom to facili-
tate cleaning hard floors.
SLIT ATTACHMENT WITH MOVABLE BRUSH
Used for cleaning difficult to access areas, such as in room corners, by and below pieces of
furniture and in bends and slits. It is also perfect for cleaning computer keyboards, drawers,
radiators or window frames.
REPLACING THE DUST BAG
To replace the dust bag, turn off the vacuum cleaner with the power switch (1) and disconnect
it from the power source. Remove the suction pipe (17) and press the (5) button to open the
upper cover (8). Remove the dust bag support (14), remove the old bag from the support and
insert a new one. The support can be placed in the vacuum cleaner in one position only. Close
the cover (8) and connect the suction pipe (17).
AIR FILTER CLEANING AND REPLACEMENT
Normal use of the vacuum cleaner requires periodical replacement or cleaning of the air filter,
which protects the motor from the side of the dust bag, and the air outlet filter. For this purpo-
se, disconnect the appliance from the power supply and detach the suction pipe.
1. Remove the motor filter (12) and HEPA filter (13). You will access the filter by lifting the cover
(8) and removing the dust bag (15). Remove the filter element (12).
2. Use a fine bristle to clean the HEPA filter (13) from accumulated dust in it. Do not wet clean
the HEPA filter.
3. Wash the engine filter element (12) in running and cool water. Dry thoroughly after washing.
Clean the filters every month or more often (depending on frequency of use). If any of the
filters are too dirty or damaged, replace them with a new one.
4. When installing the filter elements, carefully align them in the housing and the vacuum
cleaner.
CAUTION: The filter cartridge being mounted must be completely dry. Mounting a wet filter may cause an
electric shock.
13