Dab Radio Mode - Revo SuperSignal GPE024L-180133-Z Bedienungsanleitung

DAB RADIO MODE

GETTING READY FOR DAB OPERATION
Please ensure that the radio's antenna is extended before operation
in DAB Mode.
When you switch on SUPERSIGNAL for the first time, it will automatically
perform a scan to see what stations are being braodcast in your area,
before storing them alphabetically in the radio's memory.
To enter DAB MODE, press the
screen is displayed.
It may be necessary to perform a FULL SCAN from time to time,
in order to update your radio's station list. This may be required for any
one of the following reasons:
1. Station availability can change from time to time as new stations
appear, or existing stations cease broadcasting.
2. Reception was poor during the initial automatic scan, if for
example the radio's antenna was not completely extended,
it may be that the station list is incomplete or even empty.
3. You have poor reception on some of the stations (resulting in
broken or poor quality audio), you may wish to list only stations that
have a strong signal strength.
To start a manual scan, press the
from the menu list.
When the scan is complete, your radio will list all available stations.
To remove stations that are listed but unavailable, press
choose PRUNE. When asked whether you wish to "PRUNE?", select
YES.
button until the DAB MODE intro
button then select FULL SCAN
then
Scanning...
00:00
Scanning... 0
00:00
DAB Mode
00:00
Prune?
<No> Yes
00:00
Scanning... 0
00:00
DAB Mode
00:00
00:00
Prune?
<No> Yes
Prune?
<No> Yes
00:00
0
00:00
DAB Mode
00:00
Prune?
<No> Yes
00:00
Prune?
<No> Yes
41